Fujitsu FLASHWAVE 7500 - Installing Cables; Overview; Prerequisites

CHAPTER 4
ETSI Configuration
Installing Cables
4-77
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
4.16 Installing Cables
NO.SUBSECTION PAGE
This section includes the following subsections: Section
4.16.1 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-77
4.16.2 Prerequisites. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-77
4.16.3 Optical/Tributary Shelf SIA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-78
4.16.4 Installing Modem Cable (Main Optical Shelf SIA) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-79
4.16.5 Installing OSS Cable (Main Optical Shelf) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-81
4.16.6 Installing LAN Cable (Optical/Tributary Shelf ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-82
4.16.7 Installing RICC Cable (Optical Shelf ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-85
4.16.1 Overview
The procedures provided in this section cover the connections made to the Optical/Tributary
shelf station interface area (SIA) of the FLASHWAVE 7500 ETSI Configuration system. An
SIA illustration (see Figure 4-51 [p. 4-78]) shows the SIA connectors and connector
designations for the Optical/Tributary shelf.
All fiber cabling and connections to the shelf plug-in units are made during system turn-up.
Refer to System Turn-Up, for fiber cabling information. For a detailed description of
FLASHWAVE 7500 cables and shelf connectors, refer to Cable and Wiring Guide.
Note: Some of the connectors on the Optical/Tributary shelf SIA may be for future use. However,
this practice defines all connectors on the shelf SIA and applicable cables that may be used in
future releases.
Note: All cabling from the Optical/Tributary shelf SIA should be connected only to other shelves
and equipment within the same building.
4.16.2 Prerequisites
The tools required for performing the procedures listed in this section are as follows:
■
Cable termination tools
■
Common hand tools
Revision 1, June 2009