Fujitsu FLASHWAVE 7500 - Installing Fans, Rack Covers, and End Panels; Installing Shelf Fans

CHAPTER 4
ETSI Configuration
Installing Fans, Rack Covers, and End Panels
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
4-42
Fujitsu and Fujitsu Customer Use Only
4.12 Installing Fans, Rack Covers, and End Panels
This procedure provides instructions for installing the Optical/Tributary shelf fans, optional
rack covers, and end panels.
NO.SUBPROCEDURE PAGE
It includes the following subprocedures: Procedure
4.12.1 Installing Shelf Fans . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-42
4.12.2 Installing Rack Covers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-43
4.12.3 Installing Aisle End Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-60
4.12.1 Installing Shelf Fans
This procedure provides installation instructions for the four cooling fans used by the
Optical/Tributary shelf (see Figure 4-24 [p. 4-42]).
Step Task
1 If not already done, unpack four fan plug-in units from the shipping container.
2 If not already done, install a fan filter in the fan tray located at the bottom of each fan unit.
3 Install the fan plug-in units into the bottom portion of each Optical/Tributary shelf. (Refer to
Maintenance and Trouble Clearing, Section 8.8, Replacing FAN6 Plug-In Unit and Fan Filter
[p. 8-28] for detailed information.)
This procedure is complete.
Note: The connectors on the back of the fan engage the shelf backplane connectors and are secured
in place with an extractor lever (located on the left side of the fan assembly front panel).
Figure 4-24: Fan Unit (Front View)
(ETSI Configuration)
FAN6
FAIL/SVCE
FC9682FAN6
Iss. 01
m1656wy_1
Revision 1, June 2009