Fujitsu FLASHWAVE 7500 - Installing the ETSI Power Distribution Panel

CHAPTER 4
ETSI Configuration
Installing the ETSI Power Distribution Panel
4-19
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
4.6 Installing the ETSI Power Distribution Panel
The ETSI power distribution panel (PDP) (see Figure 4-8 [p. 4-19]) should be the first item
installed in the rack. After the PDP is installed at the top of the rack, the other equipment can
be installed.
Note: Fujitsu does not manufacture a power distribution panel for ETSI applications. Fujitsu
recommends using the ADC # PWX-1LFA2DF fuse panel manufactured by ADC
Telecommunications, Inc. Refer to ADC documentation for installation instructions for the ADC #
PWX-1LFA2DF fuse panel. This unit can be ordered through Fujitsu using part number
PC15L-0001-C083#01.
Note: The PDP may not have fuses A1-1 through B2-2 installed. Locate the 46-287-003 TPA 15A
or 46-290-003 TPA 30A fuse kit, if required, for labels and fuses.
Figure 4-8: ETSI Power Distribution Panel, PC15L-0001-C083#01
POWER
LVD
FUSE
TEMP
POWER
LVD
FUSE
TEMP
TPA
STYLE
FUSE
ONLY
50 AMP
MAX
RATED
A1-1
A1-2
A2-1
A2-2
A1
FUSE
VALUES
TOTAL
75
AMP
MAX
A1
FUSE
VALUES
TOTAL
75
AMP
MAX
DANGER
VORSICHT
PELIGRO
DANGER
VORSICHT
PELIGRO
A1-1
A1-2 A2-1 A2-2
+RTN
-BATT
+RTN
-BATT
+RTN
-BATT
+RTN
-BATT
TPA
STYLE
FUSE
ONLY
50 AMP
MAX
RATED
B2-2
B2-1
B1-2
B1-1
A1
FUSE
VALUES
TOTAL
75
AMP
MAX
A1
FUSE
VALUES
TOTAL
75
AMP
MAX
DANGER
VORSICHT
PELIGRO
DANGER
VORSICHT
PELIGRO
B2-2B2-1B1-2
B1-1
POWER
LVD
FUSE
TEMP
POWER
LVD
FUSE
TEMP
Designation Cards
+RTN
-BATT
+RTN
-BATT
+RTN
-BATT
+RTN
-BATT
FG
m1718pu_1
Revision 1, June 2009