CHAPTER 5
Extension Configuration
Installing Extension Shelf and Heat Baffle
5-19
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
4 Install the heat baffle as shown in Figure 5-6 [p. 5-18].
Note: The heat baffle ensures that air pushed upward through the shelf is deflected to the rear of the
rack. Use two screws on each side of the assembly.
5 Clearly mark or label each Extension shelf according to local practices.
This procedure is complete.
To Next Page
Loading...