CHAPTER 5
Extension Configuration
Installing Fans and DCM Shelf
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
5-22
Fujitsu and Fujitsu Customer Use Only
The following procedure provides installation instructions for the 23-inch DCM shelf
(SFD3):
1 Unpack the SFD3 shelf from the shipping container. The DCM units do not need to be
removed from the SFD3 shelf if they are already installed. The shelf can hold up to four
single-height DCM units, although the normal complement is two DCM units per shelf.
Figure 5-9: SFD3 (Issue 03) 23-Inch DCM Shelf Showing Fiber Diversity
Note: The shelf (SFD3) holds up to four DCM units.
For clarity, only two are shown.
DCM Shelf
Cover
Thumbscrews
Cover Removal/Replacement
Secondary Latch
DCM Unit (Two Shown)
Unit Removal/Replacement
Retaining Clips on Shelf
(for Fiber Routing)
m1718gw_1
To Next Page
Loading...