Fujitsu S1500M - ScanSnap - Document Scanner - Using the Unit in Various Ways; Scanning Only One Side of a Document

Using the ScanSnap in Various Ways (for Windows Users)
149
Using the ScanSnap in Various Ways
This section describes a variety of ways you can use the ScanSnap.
■ Scanning Only One Side of a Document
By default, pressing the [Scan] button starts scanning in Duplex mode.
When you wish to scan in Simplex mode, change the settings by following the procedure
below.
1. Select [Scan Button Settings] from the Right-Click Menu.
⇒ The ScanSnap setup dialog box appears.
2. Select [Simplex Scan (Single-sided)] in the [Scanning side] drop-down
list on the [Scanning] tab.
3. Click the [OK] button to close the ScanSnap setup dialog box.