324
Daily Care
This chapter describes how to clean the ScanSnap.
WARNING
• Before you clean the ScanSnap, turn off the ScanSnap and disconnect the power cable
from the AC outlet. Not doing so may cause a fire or electric shock.
• To avoid injuries, do not place internal parts such as pad assembly and pick roller in an
area where small children may be able to reach them.
• Do not use any aerosol sprays or alcohol based sprays to clean the ScanSnap. Dust blown
up by strong air from the spray may enter inside of the ScanSnap. This may cause the
ScanSnap to fail, malfunction or scanning errors. Sparks, caused by static electricity, gen-
erated when blowing off dust and dirt from the outside of the scanner may cause a fire.
Although the bottom of the ScanSnap may become hot when it is used, it does not affect Scan-
Snap operation, or cause any bodily harm. Be careful not to hit it to the ground when you move
the ScanSnap.
Cleaning Materials. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 325
Cleaning the ScanSnap Exterior . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 326
Cleaning the Inside of the ScanSnap . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 327
Cleaning Carrier Sheet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 330
To Next Page
Loading...
Need help?
General