Fujitsu S1500M - ScanSnap - Document Scanner - Using the Scansnap in Various Ways; Scanning Only One Side of a Document

Using the ScanSnap in Various Ways (for Mac OS Users)
263
Using the ScanSnap in Various Ways
This section describes a variety of ways you can use the ScanSnap.
■ Scanning Only One Side of a Document
By default, pressing the [Scan] button starts scanning in Duplex mode.
When you wish to scan in Simplex mode, change the settings by following the procedure
below.
1. From the ScanSnap Manager menu, select [Settings].
⇒ The ScanSnap setup window appears.
2. Select [Simplex Scan (Single-sided)] in the [Scanning side] pop-up menu
on the [Scanning] tab.