9. OTHER FUNCTIONS
9-3
Ship size and antenna position
1. Press the MENU/ESC key to open the main menu.
2. Select [8 System Setting] then [4 Correction, Offset].
3. Select [3 Ship Size/Antenna Position].
4. Enter the value for each item with the numeric keys. Refer to the figure at the right-
hand of the display.
5. Move the cursor to [Enter] then press the NU/CU ENT key.
6. Press the MENU/ESC key to close the main menu.
Attitude gauge
The attitude gauge is displayed when the data for roll, pitch or heave is received.
1. Press the MENU/ESC key to open the main menu.
2. Select [8 System Setting] then [4 Correction, Offset].
3. Select [4 Attitude Gauge].
4. Select [1 On] or [2 Off].
[On]: Displays the attitude gauge (see the illustration in "Highway Display" on
page 1-7) instead of the ship’s icon on the highway display. When the data for roll,
pitch or heave is not received, the ship’s icon is displayed.
[Off]: Hides the attitude gauge on the highway display.
5. Press the MENU/ESC key to close the main menu.
1
2
1
: Set the width and length of your ship. Enter the values as correct as possible
because these values influence the output sentence “POS”. Note that these values
are the upper limits for the values of 2 .
: Set the mounting location for the antenna unit.
X: The horizontal distance from the reference position “0” to the antenna position.
Y: The forward distance from the reference position “0” to the antenna position.
Z: The height from the ship bottom to the antenna unit.
2
To Next Page
Loading...
