9. OTHER FUNCTIONS
9-2
3. Select [1 Position Offset].
4. Enter the offset value with the numeric keys. Mark your ship’s position on the chart
to calculate the error with latitude and longitude, and enter the values. To change
the coordinate, select "N" or "E" then press one of keys from 0 to 9.
5. Move the cursor to [Enter] then press the NU/CU ENT key.
6. Press the MENU/ESC key to close the main menu.
Note: When you set the position offset, the Datum indication changes to 999 (User
Defined).
Time difference
You can display time in UTC or local. For local time, enter the time difference between
local time and UTC.
1. Press the MENU/ESC key to open the main menu.
2. Select [8 System Setting] then [4 Correction, Offset].
3. Select [2 Local Time].
4. Select [1 Off] or [2 Manual Input].
[Off]: Uses UTC (Universal Time Coordinated). Go to
step 7.
[Manual Input]: Sets the time manually. Go to step 5.
5. Enter the difference time with the numeric keys. (If
necessary, switch + and - with pressing one of
keys from 0 to 9.)
6. Move the cursor to [Enter] then press the NU/CU
ENT key.
7. Press the MENU/ESC key to close the main menu.
“LOCAL means the time
is local time.
To Next Page
Loading...
