FUTABA 7XC - Page 140

140
Function
MC (ESC) Link
(Preparation)
-
Connect the T7XC and ESC in accordance with the connection diagram shown on page 139.
-Connect the battery to ESC.
1
Turn power on the transmitter. "MC link" menu is displayed referring to the map of page 141.
Set the FET amp power switch to the ON position.
2
(ESC read)
Execute this function to read
the connected ESC type and
the data currently set at the
ESC. Tap the
[
Read]. The con-
firmation screen will be dis-
played. To execute, tap [Yes] to
hear an electronic sound and
finish setting. To cancel, select
[No] and tap it.
- "Reading succeeded" is displayed on the screen and the ESC type and currently set contents are read.
- If "Failed" is displayed on the screen , communication with the ESC is not being performed normally. Check the
T7XC and ESC connection and the battery connection to ESC and the ESC power switch and repeat [Read].
3
(Writing to ESC)
Execute this function to write the setting data to
ESC. See pages 142 to 147 for the setting data con-
tents.Tap the [Write]. The confirmation screen will be
displayed. To execute, tap [Yes] to hear an electronic
sound and finish setting. To cancel, select [No] and
tap it.
- "Writing succeeded" is displayed on the screen and the setting
data is written to ESC.
- If "Failed" is displayed on the screen, communication with the
ESC is not being performed normally. Check the T7XC and ESC
connection and the battery connection to ESC and the ESC power switch and repeat [Write].
- Different type ESC data cannot be written. If writing is attempted, "Failed" is displayed on the screen.
4
(Initialization)
Write the factory set ESC setting data to the con-
nected ESC. Tap the [Reset]. The confirmation
screen will be displayed. To execute, tap [Yes] to
hear an electronic sound and finish setting. To can-
cel, select [No] and tap it.
- "Writing succeeded" is displayed on the screen and the setting
data is written to ESC.
- If "Failed" is displayed on the screen, communication with the
ESC is not being performed normally. Check the T7XC and ESC
connection and the battery connection to ESC and the ESC
power switch and repeat [Write].
Using the ESC Link function