Charging jack
9M20A05401
(FUTM1725)
To an AC outlet.
18
Before Using
Warning
With Balance Charger
(Example: When using the
FT2F1700B/2100B
with an optional charger)
1
Remove the battery cover.
2
Disconnect the battery from the T7XC.
3
Balance charging cannot be done through the
transmitter. You must remove the LiFe battery to do
this charge.
Charging A LiFe Battery
(Example: When using the
FT2F1700B/2100B
the special charger)
1
Plug the transmitter cord of the special charger into
the charging jack on the rear of the transmitter.
2
Plug the charger into an AC outlet.
3
Check that the charging LED lights red.
4
When charging is completed, the charging LED
lights green. Disconnect the charge plug and dis-
connect the AC plug of the charger.
The charging time when charging the FT2F2100BV2
battery with the optional special charger is approxi-
mately 3 hours.
When the LiFe battery will not be used for a long
time, to prevent it from deteriorating we recommend
that it be kept in about the half capacity state instead
of fully charged. Also be careful that the battery does
not enter the overdischarged state due to self-dis-
charge. Periodically (about every 3 months) charge
the battery. In addition, always remove the battery
from the model and store it in a dry, cool place (15°C
to 25°C).
Over current protection
The transmitter charging circuit is equipped with an
over current protection circuit (1.0A). If the battery
is charged with a quick charger for other than digital
proportional R/C sets, it may not be fully charged.
The charging time when charging the HT5F1800B
battery with the optional special charger is approxi-
mately 15 hours. However, when the battery has not
been used for some time, repeat charging 2 or 3 times
to activate the battery.
Charging A NiMH Battery
(Example: When using the HT5F1800B with the special charger)
1
Plug the transmitter cord of the special charger into
the charging jack on the rear of the transmitter.
2
Plug the charger into an AC outlet.
3
Check that the charging LED lights.
When Charging The Optional Battery
Balance charging connector for LiFe battery charger.
Follow the directions of the optional LiFe chargers in use.
LiFe battery is removed from the transmitter.
Make sure not to peel off the battery fi lm, or make any scratch by a cutter knife or the sharp edges of
metal components.
Make sure not to soak or get the battery wet with water or seawater.
Make sure not to use a deformed or swollen battery.
There is a risk of explosion or fi re, which is very dangerous.
To Next Page
Loading...
