188
Reference
Reference
Specifications
Transmitter T7XC
Two sticks system, 7 channels (SFHSS System), 4 channels with TFHSS-SR, T-FHSS, FASST systems.
- Transmitting frequencies 2.4GHz band /- Transmitting RF power output: 100mW EIRP
- Futaba T-FHSS SR/T-FHSS/S-FHSS/FASST-C2
- Power requirement
(Ni-MH battery) NT5F1800B (6V)
(LiFe battery) FT2F1700BV2 (6.6V)
- Current drain 350mA or less (When the T-FHSS, Vibration off, back lighting on)
- Transmitting antenna 1/2λdipole
- 4.3 inch backlighted color TFT liquid crystal touch panel.
*When you turn on your 7XC, bright dots may appear on your screen display. Your display contains an extremely large num-
ber of TFT and is manufactured using high-precision technology. Any bright dots that may appear on your display are intrin-
sic of the TFT manufacturing technology.
Receiver R334SBS / : (T-FHSS SR /T-FHSS system, 4 channels)
- Receiving frequency: 2.4GHz band /- Telemetry Receiver RF power output: 10mW EIRP
- Power requirement: 3.7V~7.4V battery (Dry cell battery cannot be used.)
- System: S-FHSS SR/T-FHSS system (auto detection) /S.BUS2 system
- Size: R334SBS / R334SBA-E ---1.34x0.88x0.45
"
(33.9x22.3x11.3mm) (excluding a projection part)
- Weight :R334SBS ---0.26oz. (7.5g) / R334SBA-E ---0.25oz. (7.2g)
*Specications and ratings are subject to change without prior notice.
System Compatibility
The 7XC is a 2.4GHz T-FHSS SR and T-FHSS surface system. The transmitter can also be switched to
S-FHSS and FASST. (However, the telemetry system can be used T-FHSS only.) The usable receivers
are shown below. (As of May 2018)
Communications System Usable Receivers
T-FHSS SR/T-FHSS (Default) R334SBS
/ R334SBS-E
T-FHSS
R304SB/ R304SBE
S-FHSS (Change is possible)
R2104GF/ R204GF-E/ R2008SB/ R2006GS
*The analog servo mode of the S-FHSS system can use up to 7 channels. When using 5 or
more channels, R2008SB and R2006GS can be used.
FASST (Change is possible)
R614FS/ R614FF-E/ R604FS/ R604FS-E
*R3008SB, T-FHSS Air system receivers do not operate.
To Next Page
Loading...
