FUTABA 7XC - Sensor Register


Communication port.
Cover
165
Function
Sensor
Sensor Register
This function registers additional sensors. Connect the sensor as shown in the  gure and
register as follows. The sensor ID is registered in the transmitter.
This function is set when adding one telemetry sensor of the same type.
Confi rm sensor connection
1
(Start slot selection)
Tap the [Register], The confi rmation screen will be displayed. To execute, tap [Yes] to hear
an electronic sound and fi nish setting. To cancel, select [No] and tap it. If "Success" appears
on the screen, registration is complete. If registering a sensor that has already been regis-
tered is attempted, the message "Failed; The same sensor has been registered" will be dis-
played. If the message "Failed; The connected sensor is not ready." is displayed, check the
sensor connection. If it is securely connected, the sensor or the transmitter may be faulty.
2
When fi nished, return to the Telemetry screen by pressing the HOME button.
How to change start slot and set empty slot
Connecting S.BUS/S.BUS2 servo connector to the
T7XC.
Sensor (The battery is not necessary)