FUTABA 7XC - Idle-Up

Home screen
Menu screen
Menu-2
Menu-1
Linkage menu
Idle-up
70
Function
Idle-Up
Idle-Up
To use the
"
Idle-Up
"
function, switch setting by the
"
Switch select
"
function (page 67) is
necessary. This function is used to improve engine starting performance by raising the
idling speed when starting the engine of a GP car (boat). It is also effective when you want
to prevent braking when the power is turned off during running, due to the effect of your
gear ratio setting and choice of motor when operating an electronic car. However, consider-
ing safety, and to prevent the motor from rotating instantly when the power is turned on,
the MC950CR, MC851C, MC602C, MC402CR, and other Futaba electronic motor speed
controller (ESC) will not enter the operation mode if the neutral position is not con rmed.
When using the MC950CR, MC851C, MC602C, MC402CR, or other Futaba ESC, con rm
that the ESC is in the neutral position and the set is in the operation mode before setting the
idle up function switch to ON.
Warning display
If the power switch is
turned on while the
Idle-up switch is on, an
audible alarm will be
heard. Immediately set
the Idle-up switch to
OFF.
Idle-up ON/OFF is indicated on
the home screen for a few sec-
onds.
It i s d i spl ay e d i n t h e h o m e
screen, when the Idle-up is ON.
The throttle neutral position is offset to the forward side or brake side. There is no link-
age locking, etc. Because there is no change near the maximum operation angle even
when the neutral position is offset by this function.
Operation