Caution
(Commercial product)
SD standard and SDHC standard microSD cards
SD/SDHC format. Maximum size 32MB. SDXC format is not supported.
*The data in the memory card cannot be guaranteed regard-
less of the contents and cause of trouble or damage. Always
back-up the valuable data in the memory card.
(Some models may not be operated by card.)
Caution
Always use R334SBS under the following conditions:
Battery :Power requirement Rated voltage 3.8 to 7.4V (dry cell battery cannot be used)
Matched to the ratings of the receiver and connected servo.
• Transmitter’s receiver system > T-FHSS SR-SR mode channel (ON): SR mode of Futaba SR compatible servo.
• Transmitter’s receiver system > T-FHSS SR-SR mode channel (OFF):
Normal mode of Futaba SR compatible servo.
:Futaba digital servo.
• Transmitter’s receiver system > T-FHSS/S-FHSS/FASST
Transmitter’s response type: Digital servo :Futaba digital servo
Transmitter’s response type: Analog servo :Futaba all servo (Normal mode of Futaba SR compatible servo.)
Under other conditions, the set will not operate, or the specifi ed performance will not be displayed even if it operates. In
addition, it may cause trouble with servos and other equipment. Futaba will not be responsible for damage, etc. caused by
combination with the products of other companies.
Note: However, digital servos (including BLS Series brushless servo) can only be used in the
"
Digital servo type
"
.
Insert the card with the metal termi-
nals side at the front.
Remove the card by pushing it in and
then pulling it out.
Install and remove the card by push-
ing it in until you hear a click.
29
Before Using
Handling a microSD card (commercial product)
T7XC model data and telemetry log data can be saved by using a commercial microSD
card. When T7XC software updates are released, the microSD card can also be used to
make the update.
Always insert and remove the microSD card in the state in
which the transmitter power is off.
If the microSD card is removed while being accessed (read or write), the
card itself and the data may be destroyed.
Do not install and remove the microSD card with the mi-
croSD card slot facing your face.
If you remove your fingers quickly, the microSD card may fly out and
strike your face and is dangerous.
Since the microSD card is a precision device, do not subject
it to unreasonable force or shock.
-When a microSD card is installed in the T7XC transmitter, a folder called
"
Futaba
"
is cre-
ated. Folders called
"
LOG
"
and
"
MODEL
"
are created
in this folder. The
"
MODEL
"
folder stores the model
data and the
"
LOG
"
folder stores the telemetry log data.
When
"
Save screen
"
is set at the switch by switch select
(page 67), an image of the screen to be displayed on
the T7XC is saved by that switch. The saved image is stored in a folder call
"
PICTURE
"
. A
"
PICTURE
"
folder is not created until
"
Save screen
"
switch is set and the Screen Capture.
-The telemetry log data recorded on the microSD card can be converted to CSV format by
the telemetry log converter released on our home page. When copying or moving a log le,
always select both .FLI and .FLD le.
To Next Page
Loading...
