Dust cap
Bottom rubber
Bottom rubber
25
Before Using
3
Using Phillips screwdriver and a 1.5
mm hex wrench, as shown in a fi gure,
eleven screws are removed.
Note:
-When changing to a ratchet type always change
"
Throttle mode
"
(page 60) to
"
Forward
100 : Brake 0
"
. If you do not change it, the reference value for each throttle setting will be
incorrect. Also, you can cancel the settings of brakes that you do not use.
If
"
Throttle mode
"
is changed to
"
Forward 100 : Brake 0
"
, the throttle stick is not in the
stop/idle position when the transmitter is switched
"
ON
"
an alarm will sound. (For details,
see page 190.).
How to attach the ratchet plate
Changing to Ratchet Type Throttle Stick
Changing the throttle stick from the self-centering type to ratchet type that stops at an arbi-
trary position. (The ratchet plate and attaching 2 x 4 mm hexagon socket button head screw
in the accessory bag.
）
1
First remove the battery cover and the battery box. (See page 17)
Next, remove the left and right grips. (See page 23)
2
Remove the bottom rubber referring to the fi gure below. Then remove the dust cap under
the battery connector.
To Next Page
Loading...
