Communication port.
Cover
164
Function
Sensor
Sensor Reload
When using multiple sensors of the same type the sensors must be registered in the trans-
mitter. Connect all the sensors to be used to the T7XC as shown in the gure below and
register them by the following procedure. The ID of each sensor is registered in the trans-
mitter.
To load the sensor, connect all sensors to be used to the T7XC communication port as
shown below. Power supply is unnecessary. Also, to clear all sensor registration, execute
this [Reload] function without connecting sensor. The registration is cleared and all the
slots in the sensor list are unregistered.
All the sensors to be used are connected
to the T7XC.
Sensor
Sensor
Sensor
1
(Start slot selection)
Tap the [Reload], The confi rmation screen will be displayed. To execute, tap [Yes] to hear an
electronic sound and fi nish setting. To cancel, select [No] and tap it. If "Success" appears on
the screen, reload is complete.
2
When fi nished, return to the Telemetry screen by pressing the HOME button.
How to change start slot and set empty slot
To Next Page
Loading...
