FUTABA 7XC - Condition; Two Kinds of Data Can be Set in One Model

Home screen
Menu screen
Menu-2
Menu-1
Linkage menu
Condition
Tap to turn on.
When the condition function is
tur ned on, the condition copy
display becomes active and the
condition is enabled.
74
Function
Condition
Two kinds of data can be set in one model for speci c functions only; for example, two
kinds of data such as steering D/R set to 90% at normal condition and steering D/R set to
80% at second condition. This second condition can be set for each model.
-The functions that can be set at each condition are displayed by condition number at the top
of the menu screen. Since the reverse function, end point and other model standard setup
menus are not displayed by conditioner number, the condition 1 and condition 2 settings are
common.
- To use the
"
Condition
"
function, switch setting by the
"
Switch select
"
function (page 67) is
necessary.
- Switching from normal condition to second condition by switch set by switch select func-
tion is indicated by an audible alarm, and the condition number is displayed in the upper on
the screen. (The steering switch and the throttle stick switch are non-audible alarms.)
-First, the initial settings of each condition 2 function are created.
-The data set at condition 2 is memorized until reset by
"
Data reset
"
(page 174). The data
is memorized even if the condition function is turned off or setting of the switch by the
"
Switch select
"
function is changed.
Condition