FUTABA 7XC - Throttle Mode (Trigger)

Home screen
Menu screen
Menu-2
Menu-1
Linkage menu
Throttle mode (Trigger)
Forward 50: Brake 50 Forward 70: Brake 30 Forward 100: Brake 0
50 : 50
70 : 30 100 : 0
Ratio mode
Forward 50:Brake 50
Forward 70:Brake 30
Forward 100:Brake 0
60
Function
Throttle mode (Trigger)
This menu has the following 2 functions:
-Servo neutral mode:
This function allows selection of the forward side and brake (reverse) side operation ratio
from 70:30, 50:50 or 100:0 by changing the neutral position of the throttle servo.
* If
"
Throttle mode
"
is changed to
"
Forward 100 : Brake 0
"
, the throttle stick is not in the stop/idle position when the trans-
mitter is switched
"
ON
"
an alarm will sound. (For details, see page 190.).
-Neutral brake:
To use the
"
Neutral brake
"
function, switch setting by the
"
Switch select
"
function (page
67) is necessary.
* The Neutral brake, which applies the brakes at the neutral position of the throttle stick, can be set. However, when using
the MC950CR, MC851C, MC602C, MC402CR, or other Futaba ESC, conrm that the ESC is in the neutral position and
the set is in the operation mode before setting the Neutral brake function switch to ON.
Throttle servo neutral position "Ratio"
Throttle mode (Trigger)
1
(Throttle mode selection)
- Tap the [Ratio] part.
The mode list appears on the Throttle mode (Trigger)
menu screen.
Tap from the list and select the mode. To cancel, tap
[Cancel].
Selecting the Throttle mode (Trigger) ratio
2
When finished, return to the Linkage menu screen by pressing the HOME button.