FUTABA 7XC - Page 59

Brake 2 Brake 3 Brake 2&3
59
Function
Acceleration
(Preparation)
- Tap the value button of the [Forward]. Value input buttons appear
on the screen and make the following adjustments:
1
(Forward acceleration amount adjustment)
Use the [+] and [-] buttons to adjust the ac-
celeration amount.
"0" :No acceleration
"100" : Maximum acceleration (Approximately 1/2 of the for-
ward side throttle angle)
Throttle acceleration adjustment
The throttle acceleration adjustment amount (Forward), (Brake 1), auxiliary channels
(Brake 2, Brake 3) can be adjusted with digital trim DT1 to DT6 or digital dial DL1,
with the
"
Trim / Dial select
"
function (page 64).
Dial / Trim Setting
Adjustment buttons
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Forward acceleration amount
(Forward)
0~100
Initial value: 0
Brake side acceleration amount
(Brake1)
0~100
Initial value: 0
When
"
Throttle mode (Trigger) Ratio
"
(page 60) was set to 100:0, brake operation is
stopped and the throttle (brake side) cannot be adjusted.
Caution
2
(Brake side acceleration amount adjustment)
Tap the travel button of the [Brake 1]. Value
input buttons appear on the screen and use
the [+] and [-] buttons to adjust the accelera-
tion amount.
"0" :No acceleration
"100" :Maximum acceleration (Brake side maximum
throttle angle)
If the "Brake mixing" function (page 104) is
being set, the auxiliary channel brake side
acceleration will become adjustable.
3
When finished, return to the Linkage menu screen by pressing the HOME button.