FUTABA 7XC - Page 187

187
Function
Receiver update
1
Hold down the Link switch first, and turn ON the receiver.
After the LED flashes red once, release the Link switch and
then press it again.
As you continue holding down the Link switch, the LED starts
flashing red and green. (Once flashing Red and Green, the
initial process is complete. )
- If red and green do not turn on at the same time, please start over from
the beginning.T7XC and terminal screen and try again.
2
Tap the "Update" button on the screen. The update will start.
A progress bar will be displayed indicating
the progress. The LED of the receiver turns
green, and it blinks green for a moment ev-
ery time it accepts data from the T7XC.
- Do not turn off the power of T7PX while updating.
Update method
Push switch
(Link switch)
LED
Error
If an error display appeared, reinstall the update from the beginning.
- The receiver is not in the update wait state
.
- The cable is disconnected.
- The power has been turned off
- The micro SD card is not inserted in the T7XC.
- There is no data on micro SD card.
3
When the update is completed, a message is displayed on the screen, and the LED of the
receiver stays flashing green. Please turn off the power of the receiver.
Please check the operation before running (cruising).
4
When finished, return to the System menu screen by pressing the HOME button.