FUTABA 7XC - Page 184

184
Function
Calibration
(Preparation)
Tap the [Throttle]. The neutral correction screen appears.
1
(Throttle neutral adjustment)
At neutral, pull the throttle stick to full throttle and to the brake
position. Tap the [Neutral] button while the throttle stick is
in its neutral position. If the neutral position is OK, the [End
Point] button will appear after tapping the [Neutral] button. If
not within the correction range, the [End Point] button will not
appear. If not within the correction range, the end point correc-
tion screen will not appear.
2
(Throttle stick travel adjustment)
With [End Point], pull the throttle stick to full throttle and back
for braking, tap the [End Point] button. If the [End Point] cor-
rection is OK, the display will return to the calibration screen.
If not within the correction range, the display will not return to
the adjuster screen. In this case, return to the system menu by
pressing the HOME button. When operation cannot be ended
normally even when correction is repeated, and cannot be
ended normally, contact the Futaba Service Center.
Throttle adjustment
3
When finished, return to the System menu screen by pressing the HOME button.