FUTABA 7XC - Page 39

To change SR mode setting, tap
[Yes], and if you want to cancel,
tap [No].
The servo operation confi rmation message is displayed. With
this screen displayed, turn the power of the receiver off and
on again and check the operation of the servo by actually
operating it. If the servo does not operate properly, check the
SR mode setting (page 136) of the servo. Tap [Close] to close
the screen.
By tapping [Servo], you can
go directly to the S.BUS
servo menu (page 136).
Be sure to use the correct Futaba receiver and suitable Futaba servo with the T7XC.
Under other conditions, the set will not operate, or the specifi ed performance will not be displayed even if it operates. In addition, it
may cause servo trouble. Futaba will not be responsible for problems caused by the use of other than Futaba genuine parts. Use the
parts specifi ed in the instruction manual and catalog.
T-FHSS SR
T-FHSS
S-FHSS
FASST
SR mode channel: ON
SR mode channel: OFF
-SR mode of Futaba SR compatible servo.
-
Normal mode of Futaba SR compatible servo.
- Futaba digital servo.
- Normal mode of Futaba SR compatible servo.
- Futaba digital servo.
-
Futaba all servo.
(Normal mode of Futaba SR compatible servo.)
- Normal mode of Futaba SR compatible servo.
- Futaba digital servo.
-
Futaba all servo.
(Normal mode of Futaba SR compatible servo.)
- Normal mode of Futaba SR compatible servo.
- Futaba digital servo.
-
Futaba all servo.
(Normal mode of Futaba SR compatible servo.)
Digital servo
Analog servo
Digital servo
Analog servo
Digital servo
Analog servo
System
Response / SR mode Usable servos
39
Initial Set-Up
In the case of T-FHSS SR, "SR mode" which has greatly improved response compared to
the conventional T-FHSS can be used. Tap and change (ON)/ (OFF) of each channel of SR
mode. The display changes when you change it. Be sure to turn off the power of the receiv-
er before operation check.
In SR mode, ON/ OFF can be set for each channel. When using normal servo or ESC, set
the SR mode of the connected channel to (OFF).
Note:
In SR mode ON, normal servo will not operate. Please set our S.BUS servo corresponding to SR
mode to SR mode on S.BUS servo menu on page 133 and use it. Also, in case of SR mode OFF, the
servo set to SR mode cannot be used, so set the servo to normal mode by S. BUS servo menu. If using
wrong combination, servo and other equipment will fail, so please be careful.
The ESC, gyro and other equipment's not compatible with SR mode will not operate in SR mode.
Servo conforming to the setting of response / SR mode