FUTABA 7XC - Page 98

98
Function
Start
2
("Throttle point" setup)
Tap the value button of the [Throttle point].
Value input buttons appear on the screen.
Use the [+] and [-] buttons to adjust the op-
eration point.
3
("Preset position" setup)
Tap the value button of the [Preset]. Value
input buttons appear on the screen. Use
the [+] and [-] buttons to set the preset po-
sition of the throttle servo.
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Throttle point
5~95
Initial value: 30
Restart
Tap [OFF] to [Ready]
Adjust button
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Preset position
0~100
Initial value: 0
4
("Ready" setting)
To set "Ready" again, Tap [OFF] of "Sta-
tus", the display will change to [Ready] and
wait for throttle stick operation. In addition,
you can set the switch to be in the [Ready]
state in the "Switch select" function (page
67).
5
When finished, return to the Racing menu screen by pressing the HOME button.
In the [Ready] state, if the throttle stick is operated to the position of the throttle posi-
tion, the throttle servo moves to the servo operation position set with preset. It is can-
celed when the throttle stick is returned.