CS875-575-375-275-175 Installers Manual with CS5500 keypad B.12.5
2. Scroll to Feature Select>User Card Programming>Enabled and press OK.
3. The keypad beeps once to accept the change and returns to User Card Programming.
4. Enter a master user code to enter the user menu. Choose from one of the procedures outlined below.
Task Steps
Add one card
1. Select User Menu>CS1700 Proximity Readers>Add One Card.
2. Enter the user number to be assigned to the card and press OK.
3. LED1 on any enabled readers begins to flash.
4. Scan the card designated for the entered user. If the user card is not already in the system, it is added and
LED1 stops flashing. If the card is already in the system, the reader triple beeps and LED1 continues
flashing.
5. 40 seconds after you have finished scanning, all the readers in the system are updated with the new user
card information.
Add multiple users
1. Select User Menu>CS1700 Proximity Readers>Add Multiple Cards.
2. Enter the user number to be assigned to the card and press OK.
3. LED1 on any enabled readers begins to flash.
4. Scan the card designated for the entered user. If the user card is not already in the system, it is added and
LED1 continues flashing indicating that the next user card can be scanned. If the card is already in the
system, the reader triple beeps and LED1 continues flashing.
5. 40 seconds after you have finished scanning, all the readers in the system are updated with the new user
card information.
Delete one user
1. Select User Menu>CS1700 Proximity Readers>Delete One Card.
2. Enter the user number assigned to the card and press OK.
3. The user card information for the entered user number will be cleared and LED1 stops flashing. After about
40 seconds, all the readers in the system are updated with the new user card information.
Activate a card
1. Select User Menu>CS1700 Proximity Readers>Activate Card.
2. Enter the user number assigned to the card and press OK.
3. The user card information for the entered user number will be activated and LED1 stops flashing. After
about 40 seconds, all the readers in the system are updated with the new user card information.
Deactivate a card
1. Select User Menu>CS1700 Proximity Readers>Dectivate Card.
2. Enter the user number assigned to the card and press OK.
3. The user card information for the entered user number will be deactivated and LED1 stops flashing. After
about 40 seconds, all the readers in the system are updated with the new user card information.
To Next Page
Loading...
Need help?
General
