GE AKTA avant - Page 269

See sectionMaintenance actionInterval
Section 7.3.1 Change pump rins-
ing solution, on page 273
Change pump rinsing solutionWeekly
Section 7.3.2 Replace the inline
filter, on page 275
Check inline filter, replace if
necessary
Weekly
Section 7.3.3 Clean built-in frac-
tion collector sensors, on
page 276
Clean built-in fraction collector
sensors
Weekly
Section 7.4.1 Check the flow re-
strictor, on page 279
Check the flow restrictorMonthly
Section 7.4.2 Check the function
of the pump flow restrictors, on
page 281
Check pump flow restrictorsMonthly
Section 7.5.1 Clean the UV flow
cell, on page 283
Clean the UV flow cellBi-annual
Section 7.5.2 Replace the pH
electrode, on page 286
Replace pH electrodeBi-annual
Maintenance when required
The following maintenance should be performed by the user of ÄKTA avant when required.
See sectionMaintenance action
Section 7.6.1 Clean the instrument externally, on
page 288
Clean the instrument externally
Section 7.6.2 Perform System CIP, on page 289Perform System CIP (system
cleaning-in-place)
Section 7.6.3 Perform Column CIP, on page 297Perform Column CIP (column
cleaning-in-place)
Section 7.6.4 Clean built-in fraction collector, on
page 301
Clean the built-in fraction collector
Section 7.6.5 Clean Fraction collector F9-R, on
page 304
Clean the Fraction collector F9-R
Section 7.6.5 Clean Fraction collector F9-R, on
page 304
Clean Fraction collector F9-R
DropSync sensor
ÄKTA avant User Manual 29035184 AE 269
7 Maintenance
7.2 Maintenance program