GE AKTA avant - Page 270

See sectionMaintenance action
Section 7.8.1 Replace tubing and connectors, on
page 336
Replace tubing and connectors
Section 7.6.6 Storage of the pH electrode, on
page 305
Storage of pH electrode
Section 7.6.7 Clean the pH electrode, on page307Clean the pH electrode
Section 7.6.8 Regenerate dried out pH electrode,
on page 311
Regenerate dried out pH electrode
Section 7.6.12 Clean the Conductivity flow cell,
on page 318
Clean the conductivity monitor
flow cell
Section 7.7.3 Calibrate the Conductivity Monitor,
on page 327
Calibrate the Conductivity Monitor
Section 7.7.4 Calibrate the UV monitors, on
page 331
Calibrate the UV monitors
Section 7.8.2 Replace the Mixer, on page 338Replace Mixer
Section 7.8.3 Replace the O-ring inside the Mixer,
on page 340
Replace O-ring in Mixer
Section 7.8.4 Replace the UV monitor U9-M flow
cell, on page 342 and Section 7.8.5 Replace UV
monitor U9-L flow cell, on page 345
Replace UV flow cell
Section 7.8.6 Replace Flow restrictor, on page347Replace the flow restrictor
Section 7.8.7 Replace the inlet filters, on page 348Replace inlet filters
Section 7.6.11 Wipe off excess oil from the pump
head, on page 317
Wipe off excess oil from the pump
head
Section 7.6.9 Clean pump head check valves, on
page 312
Clean the check valves
Section 7.8.8 Replace pump head check valves,
on page 349
Replace check valves
See ÄKTA avant Operating InstructionsReplace pump piston seals
See ÄKTA avant Operating InstructionsReplace pump pistons
Section 7.8.9 Replace pump rinsing system tub-
ing, on page 352
Replace pump rinsing system
tubing
270 ÄKTA avant User Manual 29035184 AE
7 Maintenance
7.2 Maintenance program