GE akta start - Injection Valve

5.8 Injection valve
Introduction
Replace the complete valve when internal valve parts are damaged, worn or blocked
with salt deposits.
Use the Injection valve kit (see Section 5.9 Injection valve kit, on page 139) to service the
valve when the external parts and liquid distribution parts are damaged, worn or blocked
with salt deposits.
Required tools
DimensionTool
T10Torx driver
Instructions
Follow the instructions below to remove and replace the Injection valve.
WARNING
Disconnect power. Always switch off power to the instrument be-
fore replacing any component on the instrument or cleaning the
instrument, unless stated otherwise in the user documentation.
ActionStep
Switch off the instrument by pressing the Power Switch to the O position.1
136 ÄKTA start Maintenance Manual 29060308 AD
5 Removing and replacing modules
5.8 Injection valve