GE akta start - UV Monitor

3.5 UV Monitor
Introduction
This section describes how to access the UV Monitor options, perform calibrations and
edit UV settings.
In this section
This section contains the following subsections:
See pageSection
393.5.1 UV LED calibration
413.5.2 Diagnostics
443.5.3 Flow cell path length
473.5.4 Reset number of run hours
Access the UV Monitor options
Follow the instructions below to access the options for calibrating and troubleshooting
the UV Monitor.
ActionStep
Navigate to the Settings and service page containing the UV option (see
Navigate).
1
Tap UV to access the UV Monitor options.2
Result: The UV screen opens.
38 ÄKTA start Maintenance Manual 29060308 AD
3 Maintenance operations
3.5 UV Monitor