GE akta start - Conductivity Monitor

5.7 Conductivity Monitor
Required tools
DimensionTool
T20Torx screwdriver
Instructions
Follow the instructions below to remove and replace the Conductivity Monitor.
WARNING
Disconnect power. Always switch off power to the instrument be-
fore replacing any component on the instrument or cleaning the
instrument, unless stated otherwise in the user documentation.
ActionStep
Switch off the instrument by pressing the Power Switch to the O position.1
Remove the inlet and outlet tubing from the ports.2
132 ÄKTA start Maintenance Manual 29060308 AD
5 Removing and replacing modules
5.7 Conductivity Monitor