GE akta start - 5 Removing and Replacing Modules

5 Removing and replacing modules
About this chapter
This chapter contains instructions how to remove and replace ÄKTA start modules.
In this chapter
This chapter contains the following sections:
See pageSection
1105.1 3-Port valves
1145.2 Mixer
1175.3 UV
1225.4 UV flow cell
1245.5 Pump
1295.6 Pump tubing
1325.7 Conductivity Monitor
1365.8 Injection valve
1395.9 Injection valve kit
1425.10 Frac30 Bowl assembly
1505.11 Fuse
Introduction
The design of ÄKTA start allows all wet modules, except for the Pressure sensor, to be
easily removed and replaced by the user.
The location of modules is shown in Illustration of the instrument modules, on page 18.
108 ÄKTA start Maintenance Manual 29060308 AD
5 Removing and replacing modules