5.5 Pump
Required tools
DimensionTool
T20Torx driver
Instructions
Follow the instructions below to remove and replace the Pump.
WARNING
Disconnect power. Always switch off power to the instrument be-
fore replacing any component on the instrument or cleaning the
instrument, unless stated otherwise in the user documentation.
NOTICE
Keep the pump cover open when not using the system. Open the
peristaltic pump cover after you switch off the equipment. This re-
duces the risk of shortening the life time of the pump tubing.
ActionStep
Switch off the instrument by pressing the Power Switch to the O position.1
124 ÄKTA start Maintenance Manual 29060308 AD
5 Removing and replacing modules
5.5 Pump
To Next Page
Loading...
