GE akta start - System

3.14 System
Introduction
This section describes how to handle firmware updates and export system reports. It
also describes how to set delay volumes and switch valve timing.
In this section
This section contains the following subsections:
See pageSection
853.14.1 Firmware update
883.14.2 Export system report to USB
893.14.3 Delay volume setting
903.14.4 Switch valve timing
Options
DescriptionOption
The delay volume represents the volume of liquid
in the flow path between the outlet of the UV
Monitor and the collection tubes. This option is
used to set the delay volume (ml).
Delay volume setting
This option is used to update the instrument
firmware whenever a new firmware version is
made available on the ÄKTA start product support
page.
Firmware update
This option includes update functions for both in-
strument firmware and FPGA (field-programmable
gate array) definitions. These can be updated
separately. Files for firmware and FPGA updates
can be downloaded from the ÄKTA start product
support page (see
www.gelifesciences.com/AKTAstart).
ÄKTA start Maintenance Manual 29060308 AD 83
3 Maintenance operations
3.14 System