Connect tubing to the ÄKTA pure instrument
The table below shows recommended tubing and connectors.
Tubing
length
(mm)
ConnectorTubingConnectionTubing
label
ÄKTA pure 150ÄKTA pure 25ÄKTA
pure 150
ÄKTA
pure 25
580Tubing connector
5/16" with Ferrule
(blue), 3/16"
Tubing connector
5/16" with Ferrule
(yellow), 1/8"
FEP
o.d. 3/16",
i.d. 2.9
mm
FEP
o.d. 1/8",
i.d. 1.6
mm
Sample inlet valve port
Out to sample pump
inlet manifold
InS
optionalTubing connector
5/16" with Ferrule
(blue), 3/16"
Tubing connector
5/16" with Ferrule
(yellow), 1/8"
FEP
o.d. 3/16",
i.d. 2.9
mm
FEP
o.d. 1/8",
i.d. 1.6
mm
Sample container to
sample pump inlet mani-
fold (sample inlet valve
not used)
No
label
530Fingertight con-
nector, 1/16"
Fingertight con-
nector, 1/16"
PEEK,
o.d. 1/16",
i.d. 1 mm
PEEK,
o.d. 1/16",
i.d. 0.75
mm
Sample pump pressure
monitor to Inlet valve
port SaP
3S
The recommended location of the sample pump is on the bench to the left of the ÄKTA instru-
ment. If the sample pump is placed elsewhere, longer tubing may be needed.
Note:
ÄKTA pure User Manual 29119969 AB 111
3 ÄKTA pure external modules
3.4 Sample pump S9 and S9H
To Next Page
Loading...
