GE AKTApure User Manual

9.8.9 System settings - Wash settings
The table below describes the wash related system settings available for ÄKTA pure.
DescriptionInstruction name
System wash settings sets the flow rate used for System wash.
Note:
•
The volume for system wash is set in the System wash instruc-
tion.
•
The flow rate should not exceed 10 ml/min if narrow inlet tubing
(i.d. 0.75 mm) is used.
•
Adjust the flow rate during the system wash so that the system
pressure does not exceed 2 MPa.
System wash settings
System pump wash settings sets the flow rate and the wash
volume used during system pump washes.
Note:
The flow rate should not exceed 10 ml/min if narrow inlet tubing
(i.d. 0.75 mm) is used.
System pump wash settings
Sample pump wash settings sets the flow rate and the wash
volume used during sample pump washes.
Note:
The flow rate should not exceed 10 ml/min if narrow inlet tubing
(i.d. 0.75 mm) is used.
Sample pump wash settings
Fraction collector wash settings sets the flow rate during Frac-
tion collector wash.
Fraction collector wash settings
Mixer by-pass wash settings sets the flow rate used during Mixer
by-pass wash and defines wash volumes for mixer by-pass wash
options.
Note:
The flow rate should not exceed 10 ml/min if narrow inlet tubing
(i.d. 0.75 mm) is used.
Mixer by-pass wash settings
Loop wash settings sets the flow rate used during Loop wash.
Note:
•
The volume for system wash is set in the Loop wash instruction.
•
The flow rate should not exceed 10 ml/min if narrow inlet tubing
(i.d. 0.75 mm) is used.
Loop wash settings
462 ÄKTA pure User Manual 29119969 AB
9 Reference information
9.8 System settings
9.8.9 System settings - Wash settings

GE AKTApure Specifications

General

Brand	GE
Model	AKTApure
Category	Laboratory Equipment
Language	English