7.8.1 Replace tubing and connectors
Maintenance interval
Replace tubing and connectors when required, for example when a tubing has clogged or has been
bent so that the flow is stopped.
Required material
The following material are required:
•
Tubing and connectors
•
Tubing cutter
•
Fingertight wrench
Instruction
Follow the instruction below to replace tubing and connectors.
ActionStep
Make sure that no run is in progress on the instrument.1
Unscrew the connectors, and disconnect the tubing.2
If the tubing has labels, remove the labels to be used with the new tubing later. Discard
the tubing and connectors.
3
ÄKTA pure User Manual 29119969 AB 317
7 Maintenance
7.8 Replacement procedures
7.8.1 Replace tubing and connectors
To Next Page
Loading...
