GE AKTApure - Prepare the Flow Path

5.2 Prepare the flow path
Introduction
The flow path is defined by the user and may contain tubing, valves, pumps and monitors. This section
gives an overview of a flow path and describes how to prepare the flow path before a run.
Illustration of the flow path
The illustration below shows the flow path for a typical system configuration. The individual instrument
modules are presented in the table below. The configuration of the system is defined by the user.
4
5
6
7
8
9
10
11
12
13
14
15
16
17
W1 W2
W
3
2
1
DescriptionPart
Pressure monitor1
Sample pump2
Sample inlet valve3
ÄKTA pure User Manual 29119969 AB 151
5 Operation
5.2 Prepare the flow path