7.7 Calibration procedures
Introduction
This section provides instructions for calibration procedures that can be performed using the System
Control module in UNICORN software.
In this section
This section contains the following subsections:
See pageSection
3037.7.1 Calibrate the pH monitor
3057.7.2 Calibrate the pressure monitors
3087.7.3 Calibrate the Conductivity monitor
3127.7.4 Calibrate the UV monitors
Menu command in UNICORN
Open the System Control module and select System:Calibrate to open the Calibration dialog.
302 ÄKTA pure User Manual 29119969 AB
7 Maintenance
7.7 Calibration procedures
To Next Page
Loading...
