GE AKTApure - Accessories

2.6 Accessories
Introduction
This section describes the holders and other available accessories. These are used to attach and organize
columns, tubing and bottles to the ÄKTA pure instrument. The holders are attached to the instrument
using the holder rails on the left side and the front of the instrument.
Rail extension
The Rail extension rod can be used to attach accessories, eg., column holders or a Multi-purpose
holder. The rod has extra rails on both sides. Push the button of the rod to attach it to a holder rail.
The illustration below shows the Rail extension rod.
1 2
FunctionPart
Button1
Extension rod2
Multi-purpose holder
The Multi-purpose holder can be used to attach accessories, eg., a Loop holder or a cassette. Attach
the holder to a holder rail.
The illustration below shows the Multi-purpose holder.
1 2
3 4 3
FunctionPart
Attachment point for accessories1
Snap-in to holder rails2
Attachment points for tubing hold-
ers
3
Tab4
80 ÄKTA pure User Manual 29119969 AB
2 The ÄKTA pure instrument
2.6 Accessories