ActionStep
Connect the cable to the module to be installed.6
Insert the module.7
Fasten it with a Torx T20 screwdriver.8
A warning message is displayed at start up if a module has been installed in the instrument
but not added to the current system configuration in UNICORN.
Note:
Install internal modules in the Extension box
The Extension box can be used to install extra modules on the ÄKTA pure instrument. See Extension
box, on page 86 for more information.
ÄKTA pure User Manual 29119969 AB 79
2 The ÄKTA pure instrument
2.5 Installation of internal modules
To Next Page
Loading...
