6.1 General performance test actions
Introduction
Some actions are identical for each performance test. These actions are described in this section.
Start the performance tests
Follow the instructions to start a performance test.
ActionStep
In the System Control module, on the System menu, click Performance Test and Report.1
Result: The System Performance Test and Report dialog opens.
In the System Performance Test and Report dialog, click one of the following tests:2
ÄKTA pure 150ÄKTA pure 25
Air sensor A and inlet valve V9H-IA testAir sensor A and inlet valve V9-IA test
Air sensor B and inlet valve V9H-IB testAir sensor B and inlet valve V9-IB test
Air sensor S and Sample inlet valve
V9H-IS test
Air sensor S and Sample inlet valve
V9-IS test
Column valve V9H-C testColumn valve V9-C test
Fraction Collector F9-R TestFraction Collector F9-R Test
Fraction Collector F9-C TestFraction Collector F9-C Test
Sample pump S9H testSample pump S9 test
System Test UV U9-L (fixed)System Test UV U9-L (fixed)
System Test UV U9-M (variable)System Test UV U9-M (variable)
Click Run Performance Method.3
Result: The Start Protocol dialog of the selected test opens.
Click Next in the Start Protocol dialog to open the next page. The pages are described
in the table Overview of the Start Protocol dialog, on page 227.
4
In the last page, Result name and location, click Start.5
Result: The selected test starts.
226 ÄKTA pure User Manual 29119969 AB
6 Performance tests
6.1 General performance test actions
To Next Page
Loading...
