4.2.9 Configuration of Conductivity monitor
System properties
Follow the instruction below to update the system properties.
ActionStep
Open the system properties Edit dialog.1
Select Monitors and sensors from the Component types list.2
Select Conductivity monitor (C9) in the Component selection list.3
System settings
If the monitor is placed in the flow path between the UV monitor and the outlet valve, the delay volume
must be set. See Check/Set delay volume, on page 146.
ÄKTA pure User Manual 29119969 AB 141
4 System configuration
4.2 Configure modules
4.2.9 Configuration of Conductivity monitor
To Next Page
Loading...
