GE AKTApure - Available Run Data

9.10 Available Run data
The table below lists all available Run data for ÄKTA pure.
DescriptionRange/UnitRun Data
Status of connection and run.N/ASystem state
Total accumulated volume in the current
method or manual run.
mlAcc. Volume
Accumulated volume in the current block
(method run only).
mlBlock volume
Total accumulated time in the current method
or manual run.
minAcc. Time
Accumulated time in the current block
(method run only).
minBlock time
The current scouting number in the scouting
scheme.
N/AScouting no
The set flow rate of the system pumps.0.001 – 50.000 ml/min
(ÄKTA pure 25)
System flow
0.01 – 300.00 ml/min (ÄKTA
pure 150)
The set flow velocity of the system pumps.
Only available if a column is selected.
cm/hSystem linear flow
The set flow rate of the sample pump.0.001 – 50.000 ml/min
(ÄKTA pure 25)
Sample flow
0.01 – 300.00 ml/min (ÄKTA
pure 150)
The set flow velocity of the sample pump.
Only available if a column is selected.
cm/hSample linear flow
The set position of the inlet valve A.A1 - A7Inlet A
The set position of the inlet valve B.B1 - B7Inlet B
The set position of the sample inlet valve.S1 - S7, buffInlet S
The set concentration B or the current value
during a gradient.
0.0 – 100.0 %BConc B
The set position of the Mixer valve.N/AMixer valve
The set position of the Injection valve.N/AInjection
The set position of the Loop valve.N/ALoop position
488 ÄKTA pure User Manual 29119969 AB
9 Reference information
9.10 Available Run data