GE AKTApure - Page 259

See sectionMaintenance actionInterval
Section 7.3.1 Change pump rinsing so-
lution, on page 262
Change pump rinsing solutionWeekly
Section 7.3.3 Clean the Fraction collec-
tor F9-C sensors, on page 267
Clean fraction collector diodesWeekly
Check flow restrictorCheck the Flow restrictorMonthly
Section 7.5.1 Clean the UV flow cell, on
page 273
Clean the UV flow cellSemiannually
Section 7.5.2 Replace the pH electrode,
on page 275
Replace pH electrodeSemiannually
Maintenance when required
The following maintenance should be performed by the user of ÄKTA pure when required.
See sectionMaintenance action
Section 7.6.1 Clean the instrument externally, on page 277Clean the instrument externally
Section 7.6.2 Perform System CIP, on page 278Perform System CIP
Section 7.6.3 Perform Column CIP, on page 284Perform Column CIP
Section 7.6.4 Clean Fraction collector F9-C, on page 288Clean Fraction collector F9-C
Section 7.6.5 Clean Fraction collector F9-R, on page 290Clean Fraction collector F9-R
Section 7.8.1 Replace tubing and connectors, on page317Replace tubing and connectors
Section 7.6.6 Storage of the pH electrode, on page 291Storage of pH electrode
Section 7.6.7 Clean the pH electrode, on page 293Clean the pH electrode
Section 7.6.10 Clean the Conductivity flow cell, on page300Clean the Conductivity flow cell
Section 7.7.3 Calibrate the Conductivity monitor, on
page 308
Calibrate the Conductivity monitor
Section 7.7.4 Calibrate the UV monitors, on page 312Calibrate the UV monitor
Section 7.8.3 Replace the Mixer, on page 322Replace Mixer
Section 7.3.2 Replace the inline filter, on page 266Replace inline filter
Section 7.8.4 Replace the O-ring inside the Mixer, on
page 323
Replace O-ring in Mixer
ÄKTA pure User Manual 29119969 AB 259
7 Maintenance
7.2 Maintenance program