ActionStep
Place the support washer on top of the new seal in the front section of the pump head.
Screw the two or four screws of the support washer. Make sure to tighten the screws
fully.
3
Pump P9HPump P9
Wet a new O-ring, 21.4 x 1.6 mm, with 20% ethanol. Fit the O-ring around the support
washer.
4
Pump P9HPump P9
ÄKTA pure User Manual 29119969 AB 341
7 Maintenance
7.8 Replacement procedures
7.8.10 Replace pump piston seals of Pump P9 or P9H
To Next Page
Loading...
