DescriptionInstruction name
Drop sync on or off. It is recommended to use this setting for flow
rates below 2 ml/min. Higher flow rates can be however be used,
depending on the properties (e.g. viscosity) of the liquid.
Fractionation settings frac 2
Determines whether fraction number for the second fraction col-
lector is reset at the end of a method or not.
Note:
The default setting is Reset.
Fractionation numbering mode
frac 2
Peak fractionation parameters sets the detection parameters
for peak collection, i.e. it determines when a peak starts and ends.
This information is used by the instructions Peak fractionation,
Peak fractionation frac 2 and Peak frac in outlet valve in order
to start/end the peak collection.
Peak fractionation parameters
ÄKTA pure User Manual 29119969 AB 459
9 Reference information
9.8 System settings
9.8.7 System settings - Fraction collection
To Next Page
Loading...
