DescriptionInstruction name
Loop valve turns the Loop valve to the selected position.Loop valve
Mixer valve turns the Mixer valve to the selected position.
Note:
Setting Mixer valve in by-pass position makes it possible to use
System pump A for direct loading of the sample onto the column.
Mixer valve
Versatile valve X turns the Versatile valve number X to the selected
position.
Note:
Four sets of positions are available. In positions 1-3 and 2-4 only a
single flow channel can be used. In positions 1-4 & 2-3 and 1-2 &
3-4 the flow can be directed through two channels simultaneously.
Versatile valve X
Instruction Inlet valve X1 turns the extra valve to the selected
position. The extra valve is a basic 8 port valve, without air sensor,
to be used for general applications.
Inlet valve (X1)
Instruction Inlet valve X2 turns the extra valve to the selected
position. The extra valve is a basic 8 port valve, without air sensor,
to be used for general applications.
Inlet valve (X2)
Injection mark sets an injection mark in the chromatogram at
the point where this instruction is executed.
Note:
The instruction is useful when the sample is loaded onto the column
by the system pump.
Injection mark
472 ÄKTA pure User Manual 29119969 AB
9 Reference information
9.9 Manual instructions
9.9.2 Manual instructions - Flow path
To Next Page
Loading...
