Follow the instructions below to connect tubing to the column valves.
ActionStep
If no Column valve is installed, remove the Union F/F between tubing 5 and tubing 61
Connect tubing between Injection valve, Column valve and UV monitor
according to the table above.
2
The built-in pressure sensors for Column valve V9-C and V9H-C have to be re-calibrated after
installation. See Calibrate the monitors, on page 305.
Note:
ÄKTA pure User Manual 29119969 AB 59
2 The ÄKTA pure instrument
2.4 Instrument modules
2.4.8 Column valves
To Next Page
Loading...
