DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
Chapter 8 Replacement Procedures 8 - 19
5.
Once the C Partition Software Load is
complete, the system will display the
following message.
Please press any key to shutdown.
Remove media prior to system restart.
6.
You will see several screens as the
Application Software is being loaded; let it
run.
At this point, the load time will be
approximately 20 minutes.
7.
Once the Application Software installation
is complete the LOGIQ E10 will restart
twice.
When the LOGIQ E10 restarts, it will be
active and ready for testing and set-up.
Table 8-9 Loading C Partition Only Software
Steps Corresponding Graphic
To Next Page
Loading...
